|
This utility will assist
you in in the selection of a gearhead -pinion-rack system for your
liner motion application. The offer combination is listed /
calculated based on the peak linear force and peak speed. In case the
the linear force an speed is unknown the utility offers the option to calculate
this values foe triangular and trapezoidal motion profile. The utility
is using layer structure which are activated by checking the
radio button associated with the layer.
To select the right Neugart
gearhead- Pinion - Rack for your linear motion application proceed as follows:
- if you know the peak liner force and peak velocity, activate the PLSR
(high precision) or PLER (precision) layer, enter the values an click
the calculate button click the
- if peak linear force and velocity is
not not available use the triangular or trapezoidal motion profile
calculation utility to determine this values. The calculated values are automatically
forwarded to the PLSR / PER selection layer.
- the PLSR / PLER selection
assistant will for a selected Gearbox ration calculate and list
the torque requirement at the pinion (Gearhead output) , the required
peak motor rpm and the reflected inertia to the motor shaft. Based on
this values select which Gearbox + Pinion is the appropriate for
your motor / system. The rated torque shall be larger or equal to the calculated
torque requirement. Both values are shown in adjacent columns.
- depending upon your travel length
module and precision select the rack part number and the quantity
of required rack segments. The rack part numbers are
listed below calculation charts .
Always consider the lubrication
requirements !
|